Canon Super G3 Fax Board-AF1, Service Manual

Page: 24 / 74

Chapter 2
2-4
5) Remove the Right Shield Plate [1].
- 2 Screws [2]
F-2-12
6) Disconnect the 3 Cables.
- 3 Connectors [1]
- 6 Wire Saddles [2]
F-2-13
7) Remove the Speaker Unit Base [1] and the Grounding Wire [2].
- 2 Screws (P Tightening) [3]
- 1 Screw (RS Tightening) [4]
F-2-14
8) Install the Speaker Unit [1] to the Speaker Unit Base.
- 3 Harness Guides [2]
- 1 Connector [3]
F-2-15
9) Place the Speaker Unit, and install the Speaker Holder [2].
- 2 Protrusions [2]
- 2 Screws (P Tightening; M4x10) [3]
F-2-16
10) Return the Speaker Unit Base and the Grounding Wire to their original
position.
- 2 Screws (P Tightening)
- 1 Screw (RS Tightening)
11) Reconnect the 3 Harnesses disconnected in step 6) to their original posi-
tions.
CAUTION:
Do not touch the area [1] shown in the figure. This may cause wiring
disconnection.
CAUTION:
If the tie-wrap [1] overlaps on the cable with tube [2], this may cause the
tube to be ripped, so be sure to route the cable not to be overlapped by the
tie-wrap [1].
[1]