5
5
5-2
5-2
Adjustment at Time of Parts Replacement
Adjusting the Tray Full Sensor Position
Be sure to go through the following whenever you have removed/replaced the tray full
sensor (front, rear):
1. Remove the 3 face covers [1].
2. Remove the 2 screws [1], and detach the shift drive unit [2].
x2
Cap
Cap
●
•
F-5-1
F-5-1
3. Loosen the screw [1], and temporarily fix both of the tray full sensors [2] in place where
they are farthest from the paper.
[1]
[2]
[1]
[2]
4. Place a stack of paper about 60 mm in height over the point of detection of either of the
tray full sensors on the shift tray.
60mm
F-5-2
F-5-2
F-5-3
F-5-3
Summary of Contents for Shift Tray-E1
