5
5
5-4
5-4
Adjustment > Adjustment at Time of Parts Replacement
Adjustment > Adjustment at Time of Parts Replacement
Inserter height adjustment (after replacing the inserter unit)
<Pre-check>
With the inserter closed, check whether the gap between the right side of the inserter and the
finisher is within ±1 mm at the front and back (A and B).
If it is not within ±1 mm, make the height adjustment as the following procedure.
<Adjustment method>
1. Remove the rear cover.
[1]
■
F-5-11
F-5-11
F-5-12
F-5-12
2. Increase the top cover open/close angle.
Remove one screw to remove the upper cover angle restriction shaft [1].Open the top cover.
x1
[1]
[2]
3. Loosen two screws to remove the front cover.
[2]
[1]
F-5-13
F-5-13
Summary of Contents for K1
