COPYRIGHT © 2002 CANON INC.
2000 2000 2000 2000
CANON iR1200/iR1300 Series REV. 0 AUG. 2002
CHAPTER 7 TROUBLESHOOTING
7-66
##107 [RX]
The transmitting machine cannot use fall-back
The line condition is poor, and the signal from the other party cannot be received
correctly even at 2400 bps.
1. Ask the operator of the other party to increase the transmission level so that the
signal may be received correctly.
2. Adjust the NL equalizer so that the signal may be received correctly.
3. Loosen the RTN transmission conditions so that RTN will not be transmitted.
The machine malfunctioned because of an echo.
1. Provide echo remedy 1.
2. Decrease the transmission level so that an echo of the transmitted signal will
not be received.
##109 [TX]
After transmitting DCS, a signal other than DIS, DTC, FTT, CFR,
and CRP was received, exceeding the permitted number of trans-
missions of the procedure signal
The procedure signal is faulty.
Record the protocol on a DAT or MD, and have it analyzed by the local Canon
office and/or Technical Center.
While printing data stored in the image memory, the effects of noise caused a data
error.
Print out all image data and system data, and execute all-clear; then, store the sys-
tem data once again.
Noise started wrong dialing.
Replace the image processor PCB.
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
The line condition is poor, and the image signal from the other party cannot be
received correctly.
1. Ask the operator of the other party to increase the transmission level so that the
image signal may be received correctly.
2. Ask the operator of the other party to decrease the transmission start speed.
3. Adjust the NL equalizer so that the image signal may be received correctly.
4. Loosen the RTN transmission conditions so that RTN will not be transmitted.
The machine malfunctioned because of an echo of CFR.
1. Provide echo remedy 2.
2. Decrease the transmission level so that an echo of transmitted CFR will not be
received.
##111 [TX/RX]Memory error
##114 [RX]
RTN was transmitted