Canon iR105 Series, Service Manual

Page: 692 / 1029

ERROR CODE
E-1
COPYRIGHT© 2001 CANON INC. 2000 2000 2000 2000 CANON iR105 REV.0 JULY 2001
1 Error Codes
1.1 Outline of Error Codes
The CPU on the machine’s main controller PCB and DC controller PCB is equipped with
a self diagnostic mechanism that monitors the condition of the machine (especially of the
sensors); upon detection of a fault, it indicates the fact in the control panel using an error
code.
A description of each code and the timing of its detection are as discussed hereafter; the
suffix that may follow each code is a detail code, which may be checked in service mode
(COPIER>DISPLAY>JAM/ERR).
The error codes are grouped as follows according to the items they refer to:
E000 to E399
error code related to the copier
E400 to E499 error code related to the ADF
E500 to E514 error code related to the finisher
E515 error code related to the inserter
E518 error code related to the paper folding unit
E530 to E595 error code related to the finisher
E5F0 to E5F9 error code related to the saddle stitch assembly
E601 to E830 error code related to the copier
When the self diagnostic mechanism has gone ON, the machine may be re-
set by turning its power switch. This, however, does not apply to E000,
E001, E002, E003, E004, E005, E013, E020, or E717, indicating a fault
which can lead to serious consequences if the machine is reset without re-
moving the cause (i.e., melting thermistor, which will overheat the fixing
roller, or overflowing of toner from the hoper).
If the code is from E000 to E003, the power switch will go OFF in about 30
sec if it is turned ON without resetting; in the case of E004, the power
switch will go OFF in about 3 sec after indicting E000 if the power switch
is turned ON without resetting.
You will have to clear the data in the RAM on the DC controller PCB for
the following: E000, E001, E002, E003, E004, E005, E013, E020, and
E717.