Canon iR105 Series, Service Manual

Page: 653 / 1029

COPYRIGHT© 2001 CANON INC. 2000 2000 2000 2000 CANON iR105 REV.0 JULY 2001
SERVICE MODE
S-92
FUZZY
Use it to set fuzzy control (on/off) and environment settings
• It affects the pre-transfer, transfer, and separation charging current
levels.
• Setting it between ‘1’ and ‘3’ makes the control independent of the
readings of the environment sensor.
Setting 0: fuzzy control ON (default)
1: low humidity environment mode (uses level lower than standard)
2: normal humidity environment mode
3: high humidity environment mode (uses level higher than standard)
SCANSLCT
Use it to turn ON/OFF the original size detection mechanism by the ADF.
When ON, the scan size is determined according to the size of an
original.
Setting 0: OFF (default)
1: ON
OHP-TEMP
Use it to switch among temperature settings for transparency mode.
The fixing temperature will be lowered to improve separation of
transparencies from the fixing roller.
Setting 0: 198°C (default)
1: 193°C
2: 188°C
3: 183°C
OHP-CNT
Use it to turn ON/OFF the potential control mechanism for transparency
mode.
Setting 0: use target value obtained in potential control of transparency mode
(default)
1: do not use potential control in transparency mode
CNT-W/PR
Use it to turn ON/OFF the mechanism to change density during printing
(PDL input).
Setting 0: correct target value to enable change of density during printing (de-
fault)
1: do not change density during printing
Memo
Memo
Memo
COPIER>OPTION>BODY