CHAPTER 3 DISASSEMBLY & REASSEMBLY
3. Upper Cover
Notes on assembling
If the one-way bearing has become
detached, install it with the display
surface of the one-way bearing facing
the outside and aligned with the position
setter.
1) While holding down the end of the upper
cover, unhook the 4 fitting parts
{
1
on
the bottom side using a tool. Next,
unhook the 2 pairs of fitting parts
{
2
on
the top side and remove the upper cover
{
3
.
Note:
Unhook the fitting part on the bottom
side by bending the hooks in the
downward direction while pushing
towards the far side. When you
remove the upper cover unit, lock
lever shaft and coil spring on the
inside may become detached.
Figure 3-103
Figure 3-104
3-2
COPYRIGHT
©
CANON ELECTRONICS INC. 2011 CANON DR-M160 FIRST EDITION
