Canon imageCLASS LBP913w, User Manual

Page: 245 / 327

Did you print on the back of a printed sheet?
● Printing may be faint when you print on the back of a printed sheet. Setting <Special Printing Mode R> to
<On> may solve the problem.
<Special Processing>(P. 192)
● If you set to <On>, image quality may be affected or a paper jam may occur when a certain length of time
elapses after printing on the front side or depending on the ambient humidity.
Is the machine installed in the appropriate environment?
● Install the printer in an appropriate location.
● The print quality may be faint, light or faded depending on the installation environment. Avoid placing the
machine in a location exposed to wind.
Installation(P. 3)
Relocating the Machine(P. 217)
Is the amount remaining in the drum cartridge running low?
● Check how much the amount remaining in the drum cartridge is left, and replace the drum cartridge as
necessary.
● Regardless of the amount remaining in the drum cartridge, the drum cartridge may reach the end of its
lifetime depending on the use environment or the deterioration of materials inside the drum cartridge.
Replacing the Drum Cartridge(P. 212)
A Portion of the Page Is Not Printed
Do you print data without margins?
● This symptom occurs if a margin is set to none in the printer driver. A margin of 5 mm or less around the
edge of paper or 10 mm or less around the edge of envelopes is not printable with the machine. Make
sure to have margins around the document to print.
[Finishing] tab [Advanced Settings] [Expand Print Region and Print] [Off]
Do the paper guides align with the edges of the paper?
● If the paper guides are too loose or too tight, part of a document may not be printed.
Loading Paper(P. 87)
Troubleshooting
240