Canon i-SENSYS LBP5300 Series, Service Manual

Page: 135 / 150

Chapter 5
5-9
5.3.3 A4-XX_ERROR
0014-7331
/ i-SENSYS LBP5360
T-5-5
5.3.4 A5-XX_ERROR
0014-7332
/ i-SENSYS LBP5360
T-5-6
5.3.5 A7-XX_ERROR
0014-7333
/ i-SENSYS LBP5360
0001 Not enough HDD space
Occurs when the capacity of the installed HDD is smaller than an HDD space
required for a software. -
0002 Downloading the controller firmware has been failed. - Download the controller firmware again
- Replace controller PCB assembly
0003 HDD access error
Error caused by a device or hardware in HDD access while executing bootrom.
(Sector failure, device is busy, etc.) Replace HDD
E604 Error in lacking of memory capacity
0000 Lack of memory capacity - Remove and insert the expanded memory
- Replace the expanded memory to the correct one
- Replace the controller PCB
E733 Error in communication of printer system
0001 Error in communication between the DC controller PCB and the video
controller PCB (DC controller PCB factor). - Reactivation of power
- Replace the DC controller PCB
0004 Undefined command error
0005 Communication timeout error
0006 Unknown communication error
E744 Error in invalid ID code when downloading firmware for controller
1000 Recognizing the invalid ID code when downloading firmware for controller. Check each project ID, and download the firmware with valid
project ID.
E760 Error in software program for video controller
0000 Fault of software program for the video controller - Download the correct firmware for the video controller
- Replace the video controller PCB
E804 Error in power supply fan
0000 Description
The fan lock detection signal is input for about 10 sec or longer continuously.
Cause
Power supply fault, DC controller PCB fault.
- Replace the power supply fan
- Replace the DC controller PCB
E805 Error in duplexing fan/CPU fan
0003 Description
The CPU fan lock detection signal is input for about 10 sec or longer
continuously.
Cause
CPU fan fault, video controller PCB fault.
- Replace the CPU fan
- Replace the video controller PCB
0005 Description
The duplexing fan lock detection signal is input for about 10 sec or longer
continuously.
Cause
Duplexing fan fault, DC controller PCB fault.
- Replace the duplexing fan
- Replace the DC controller PCB
E840 Error in pressure release mechanism
0000 Description
Although passing 2.5 sec from the start of HP control, HP (pressure condition)
cannot be controlled.
Cause
Fixing drive assembly fault, fixing pressure release cam fault.
- Replace the fixing drive assembly
- Replace the fixing pressure release cam
Number field Description Corrective action
A4-00 to 06 A fault exits in the software program of the video controller. - Turn off and then on the power.
- Replace the video controller board.
Number field Description Corrective action
A5-00 to 07 A fault has occurred while image data is being processed by the controller. 1) Turn on the power.
2) If step 1 fails, increase the memory.
3) If step 2 fails, replace the control board.
Code Description Action