Canon Finisher-R1, Service Manual

Page: 119 / 177

Chapter 4
4-44
F-4-154
5) Release the claw [13] of the stack delivery roller
rear side clutch [12] and remove the clutch [12].
6) Remove the E ring [14] and bushing [15] and
remove the stack delivery roller.
F-4-155
7) Disconnect the connector [16] and remove harness
from the clamp and edge saddle [17].
8) Remove two screws [18] and pull out the
processing tray [19] in the paper delivery direction.
When removing parts inside the processing tray,
be careful not to exert force on the aligning plate
(front/rear) or the rear end stopper plate.
F-4-156
4.3.6.10
Removing the Swing
Unit
0004-4673
1) Remove screw [1] and pull up the swing pressure
guide [2].
F-4-157
2) Remove two E rings [3] at the joint between the
swing unit and the return roller unit and then slide the
two return roller unit collars [4] inside.
3) Unhook the swing pressure rack [5] from the swing
unit center hook.
4) Remove the belt on the gear [6] at the rear side of
the swing unit and then pull out the swing unit [7]
from the delivery direction.
The parallel pin [8] drops when the gear [6] is
removed. Be coreful not to loose it.