Canon Color image RUNNER LBP5360, User Manual

Page: 351 / 444

8-54
T
roub
leshooting
8
When You Cannot Obtain Appropriate Printout Results
Cause 2 When UFR II Printer Driver was not used, custom size paper was loaded in
landscape orientation to print.
Remedy Load the paper in portrait orientation, then print again.
Cause 3 Paper of the size smaller than the data size is loaded.
Remedy Load the paper of the size that matches the data size or print the data in the
reduced size that matches the paper size. (See Driver Guide)
Cause 4 The position of the paper is incorrect.
Remedy Load the paper properly and print again. (See "Printing from the Paper
Cassette," on p. 4-17, "Printing from the Multi-purpose Tray," on p. 4-35)
Cause 5 A document with no margins was printed.
Remedy 1 If you are using UFR II Printer Driver, secure a margin of 0.20 in. (5 mm) or
more (0.39 in. (10 mm) or more for envelopes) around the data, then print again
(Data cannot be printed within a 0.20 in. (5 mm) margin (0.39 in. (10 mm) for
envelopes) on all sides of the paper). (See the instruction manual supplied with
your application)
Remedy 2 If you are using PCL Printer Driver, secure a margin of 0.17 in. (4.23 mm) or
more (0.39 in. (10 mm) or more for envelopes) around the data, then print again
(Data cannot be printed within a 0.17 in. (4.23 mm) margin (0.39 in. (10 mm) for
envelopes) on all sides of the paper). (See the instruction manual supplied with
your application)
IMPORTANT
You may not obtain the optimum print quality when printing data with no margin
using the PCL printer driver. It is recommended to secure a margin of 0.20 in. (5
mm) or more around the data.
Remedy 3 If you select the [Print with Upper Left of Sheet as Starting Point] check box in
the [Finishing Details] dialog box in the UFR II printer driver, the printer prints
with its printable area expanded.
IMPORTANT
Depending on the print data to be printed, the edge of paper may be missing partly
during printing or may blot during color printing.
Cause 6 The printing position has been adjusted using ADJ.START POS. in the USER
MAIN. options in the SETUP menu.
Remedy Adjust the printing position to the appropriate value using ADJ.START POS. in
the USER MAIN. options in the SETUP menu. (See "Adjusting the Printing
Position," on p. 7-21)