© 2001 Cannondale Corporation - All Rights Reserved
80
X440s Owner's Manual.fm
FOOTPEG PIVOT LUBRICATION)
1.
Place the vehicle on a stand.
2. Clean the footpeg.
3. Spray the footpeg with a water-displacement
chemical, wipe them off, and dry them thoroughly.
4. Apply a light coat of clean engine oil onto the footpeg
pivot bolt.
REAR BRAKE PEDAL LUBRICATION
1.
Place the vehicle on a stand.
2. Remove the mounting bolt (1) and remove the brake
pedal (2).
3. Spray all the parts with a water-displacement
chemical, wipe them off, and dry them thoroughly.
4. Apply a light coat of a high quality waterproof grease
onto the mounting bolt and rubber seals.
NOTE : Only apply a light coat of grease so it does not
attract a lot of dirt and debris.
5. Install the pivot bolt and brake pedal, and tighten the
bolt to the specified torque
TORQUE : Brake, pedal, rear, mounting bolt.
15.0 lbf•ft (20.3 N•m)
6. Adjust the brake pedal height if necessary.
1.
Footpeg
2.
Cotter pin
3.
Spring
4.
Pivot pin
5.
Bolts
1.
Mounting bolt
2.
Brake pedal
1
2
3
4
5
5
2
1
WARNING
POTENTIAL HAZARD
Riding without checking the brakes.
WHAT CAN HAPPEN
Leaving the rider without a rear brake, which can
lead to an accident resulting in injury or death.
HOW TO AVOID THE HAZARD
Check brake pedal height and rear brake operation
before every ride!
