© 2001 Cannondale Corporation - All Rights Reserved
24
X440s Owner's Manual.fm
CHANGING THE TRANSMISSION OIL
CAUTION
When re-installing the transmission oil filter, be sure
to insert it into the drain bolt, then insert the pair
into the crankcase hole together. This helps assure
that the other end of the filter will locate into the
back of the transmission oil pump (rear of cartridge
plate inside gearbox cavity). If the filter does not
locate into the plate hole, unfiltered oil can enter and
damage the pump.
NOTE : The transmission drain bolt is located on the right
side of the engine. The filter (screen) may not come out with
the drain bolt. After the oil drains, use needle nose pliers to
gently remove it from within the drain hole.
Take notice of the sealing washer on the bolt when you
remove it.
1.
Place vehicle on a level surface.
2. Place a suitable container under transmission drain
bolt and remove the bolt.
3. Allow the transmission oil to drain completely.
4. Lean the vehicle slightly to the right to ensure all oil is
drained.
5. If the filter did not come out with the bolt, remove it
carefully from the hole. Clean it using compressed
air.
6. Inspect the filter for cracks, holes, tears, and other
damage. Replace new if damaged.
7. Make sure the threads of the bolt and crankcase are
clean.
8. Apply anti-seize compound to the threads of the
transmission drain bolt (1). Then install the sealing
washer (2) onto the bolt with the flat side (a) facing
WARNING
POTENTIAL HAZARD
Blindness, eye injury,
WHAT CAN HAPPEN
When cleaning the oil filters, objects propelled by
compressed air can strike your eyes and cause
serious injury or blindness.
HOW TO AVOID THE HAZARD
Wear safety glasses when working with compressed
air.
