Cannon imageRUNNER 5075, Support Manual, Page: 238 / 268

Service Call Message 3-100
3
T
rou
b
lesh
o
o
ti
ng
Setting the Limited Functions Mode from the Service Call
Message Screen
If the Service Call Message screen appears indicating a malfunction of a Finishing
mode, you can clear it by turning Limited Functions Mode 'On' to temporarily limit
the use of the finishing modes. However, after the Limited Functions Mode is
deactivated, the Service Call Message screen may appear again, unless the cause
of the malfunction is removed.
IMPORTANT
If you turn OFF the main power switch when there is a job waiting to print, that job is
erased.
NOTE
If you set Limited Functions Mode to 'On' from the Service Call Message screen, Limited
Functions Mode in Common Settings (from the Additional Functions screen) is also set to
'On'. (See Chapter 4, "Customizing Settings," in the
Reference Guide .)
1
Press [Limited Fnctns Mode].