9
Do not use fire with broken or missing logs.
Gas type:
Natural or Propane gas, as indicated
on data label
Gas consumption:
26 MJ/hr input
Energy star rating:
3.77
Energy output:
20.7 MJ/hr
Heater type:
Heater approved to AG 103.
Operating pressure:
Natural gas: 1.0 kPa
Propane gas: 2.65 kPa
Gas regulator:
Integral with controller (NG)
Min. inlet pressure:
1.13 kPa (NG)
Propane gas: Regulated to supply 2.70
kPa to appliance
Fan:
Three speed
Controller:
Electronic
Minimum cavity
Height: 605mm dimensions*
dimensions
Width: 695mm
Depth: 385mm
Power requirement:
240 VAC 10 A
Optional Accessories:
• Safety guard
• Gold trim
• Mock fireplace installation kit*
Overall dimensions:
Refer fig. 8
*For installation into a non-combustible fireplace,
ie: masonry or brick or into a mock fireplace, i.e.
timber or plasterboard.
Note: when installing into a mock fireplace a
mock fireplace heater must be used.
Model no’s: CANTIBM & CANTIBMLP.
Heater Specifications
8
12
11. Remove the inner glass. Slacken off screws in top clamp and
remove side clamps. Refer figure 16.
12. All gaps between heater case and fireplace are to be sealed.
Seal with foam tape around top and sides of heater flange as
required. Refer figure 17a.
Seal with fibreglass between bottom of heater case and base
of fireplace.
13. Slide heater into the fireplace ensuring that gas inlet pipe is fed
through the hole at the rear bottom RHS of the heater. Refer
figure 18 and gas connection figure 19.
-
14. With heater in position, flanges should be hard against 7asonry.
Secure case flanges to the masonry. Refer figure 16b.
Installation instructions continued
18
Sealing
17a
17b
16
