7
5. To increase the fan speed to MED, press switch for MED set-
ting. Refer figure 5.
6. To increase the fan speed to HIGH, press switch for HIGH
setting. Refer figure 6.
7. To turn the burner to LOW setting, press switch for LOW
setting. Refer figure 7.
On low burner setting it is more efficient to operate the fan
speed on LOW.
8. If the burner fails to ignite, wait 20 seconds and repeat the
ignition procedure. See below.
To turn burner OFF
To turn burner ON
5
6
7
14
b) Place log No.2 onto the 2 left back pins. Refer figure 22.
c) Place log No.3 on single right front pin, ensure fork
locates over log No. 2, see figure 23.
d) Place log No. 4 on single right back pin, ensure left side
of log rests on depression in No. 3 log, see figure 24.
18. Refit the inner glass, making sure not to overtighten the screws.
19. Refit the front glass surround. Ensure that the glass surround is
replaced the correct side up. The rearward sloping frame must
be at the top and the vertical ledge must be at the bottom.
Refer figure 25.
20. Reconnect the switch loom to the loom plug.
21. Refit the front glass surround.
22. Connect plug to the wall socket and switch it on.
20
23
22
24
25
