USE THE DISHWASHER
13 GB
Memorization of the last programme used
The last programme used can be memorized by following the
below:
IMPORTANT
The dishwasher must ALWAYS be off before start of this
procedure.
1. Hold down the
"PROGRAMME SELECTION"
button and at
the same time switch on the dishwasher by pressing the
212))
button (a brief audible signal will sound).
2. Keep the
"PROGRAMME SELECTION"
button pressed for at
least 30 seconds (during this time, 3 audible signals will sound).
3. Release the button when the
THIRD
audible signal sounds (all
the indicator lights will flash).
4. Press the same button again: the flashing indicator light
(memorization off) will stop flashing and remain on (memorization
on).
5. Turn off the dishwasher by pressing the
212))
button to
confirm the new setting.
To disable the memorization, follow the same procedure.
WARNING!
If any problem occurs, turn the dishwasher off by
SUHVVLQJWKH212))EXWWRQDQGVWDUWWKHSURFHGXUH
again from the beginning.
Fault Signals
If malfunctions or faults occur when a program is running, the LED
that corresponds to the selected cycle (2 LEDS for COLD RINSE
programme) will blink rapidly and an audible signal will be activated.
In this case, turn the dishwasher off by pressing the On / Off button.
After checking to make sure the water inlet hose tap is open, that
the drain hose is not bent and that the siphon or filters are not
clogged, re-start the selected program. If the anomaly persists,
contact Customer Service.
Important !
T
R HQVXUH WKH FRUUHFW RSHUDWLRQ RI WKH DQWLRYHUIORZ VDIHW\
device, it is recommended not to move or to tilt the dishwasher
during operation.
If it is necessary to move or to tilt the dishwaher, first make
sure the washing cycle is finished and that no water is left in
the tank.
If there is any break in the power supply while the dishwasher is
operating, a special memory stores the selected programme and,
when the power isrestored, it continues where it left off.
$WWHQWLRQ7KHGLVKZDVKHULVHTXLSSHGZLWKDQDQWLRYHUIORZ
safety device which in the event of anomaly intervenes by
evacuating water in excess.
The filtering system is composed
of
:
- a central filter cup which traps the
largest food particles.
- a flat filter which continuously filters
the washing water.
- the micro filter, situated under the
flat filter, which traps the smallest food particles ensuring a
perfect rinse.
For best results, the filter unit should be checked and cleaned
after each wash.
To remove the filter unit, simply grip the handle and lift the whole
unit out.
The central cup is just resting on top for easy cleaning.
The dishwasher is fitted with a self cleaning micro filter, which only
requires checking about once every 15 days.
However, it is advisable to check after every wash, that the central
cup and the flat filter are not clogged.
NB : After cleaning the filters, make sure that they are correctly
reassembled, one inside the other, and that the flat filter is properly
positioned at the bottom of the dishwasher.
A poor seating of the filter unit could have an adverse effect on
the efficiency of the appliance.
Important : Never use the dishwasher without filter.
PRELIMINARY OPERATIONS AND
CLEANING THE FILTER UNIT
