27
INSTALLATION : CHANGING THE GAS
Hob burner jets
To gain access to the jets :
. lift the hob lid,
. remove the top grills, caps and heads of all burners,
. use a tube spanner (7) inside the burner,
. according to the information given in the table, install
jets suitable for the burner type and gas type supplied.
For reinstallation, fit the heads, burner and top grills.
HOB BURNER JET
INSTALLATION : GAS CONNECTION
This must be done in compliance with the regulations in force in the installation country. In
all cases, on the gas feed pipe provide a stop cock, a regulator or regulator release device
for propane gas. Only use valves, regulators ends and flexible tubes, regulators with the
official mark of the installation country.
Gas connection according to installation :
Natural
Rigid, Flexible hose with mechanical fittings (1) - Soft rubber tube (3)
Butane
Rigid, Flexible hose with mechanical fittings (1) - Soft rubber tube (2)
Propane
Rigid, Flexible hose with mechanical fittings (1) - Soft rubber tube (2-3)
1 - provided that flexible hose can be inspected for its entire length.
2 - provided the soft rubber tube can be inspected for its entire length, its length does
not exceed 1.5 metres and it is fitted wit suitable clamps at the ends.
1, 2 - soft tubes and flexible hoses with mechancial fittings must be arrange to be away
from any flames, and not deteriorated by the combustion gases, hot cooker parts or by
any spills of hot food.
THREE CONNECTION OPTIONS :
• RIGID PIPE CONNECTION
Connect directly to the manifold fittings.
• CONNECTION BY FLEXIBLE HOSE WITH MECHANICAL FITTINGS
We recommend this type of connection.
Screw the hose nuts directly onto the manifold fitting on the one hand and onto the stop
cock of the piping on the other hand.
Summary of Contents for CGE 650 S
