7. Normal operation
7. Normal operation
7.5.10 HMI Update
HMI
Current
Ver
.: 02
YES
=<
ENT
>
NO
=<
ESC
>
Selecting “Updater” displays the sub-menu shown below:
This section is applicable to maintenance personnel only.
Updater is for updating LCD firmware.
Press the ENTER key to start the process.
Press the ESC key to return to the previous menu.
Figure 7.46
7.5.9 Restore Settings
There are 5 items in initial setting submenu.
The
screen
shows
as
below
:
Restore setting could set all item in 7.5.7 special setting to default.
Figure 7.45 Restore Settings
Are
you
sure
?
YES=<ENT> NO=<ESC>
Press
the
Enter
key
to
save
the
setting
after
setting
grid
off
.
Press
the
ESC
key
to
return
the
previous
mean
.
7.5.11 Restart HMI
The
function
is
used
for
restart
the
HMI
.
This function is applicable by maintenance personnel only, wrong operation
will prevent the inverter from reaching maximum power.
7.5.12 FAN Test
This section is applicable to maintenance personnel only.
Figure 7.47
Selecting “Fan Test” displays the sub-menu shown below:
Are
you
sure
?
YES
=<
ENT
>
NO
=<
ESC
>
Fan Test is a factory test function.
Press the ENTER key to start the test.
Press the ESC key to return to the previous menu.
7.5.13 DSP Update
The function is used for update the DSP.
This function is applicable by maintenance personnel only, wrong operation
will prevent the inverter from reaching maximum power.
7.5.14 Compensation Set
The
screen
shows
:
Figure 7.48 Power Rate Limit
Press the Down key to move the cursor. Press the Up key to change the digit. Please press
the Enter to save the setting and press the ESC key to return to the previous menu
.
This setting is used for grid operators, do not change this setting unless
specifically instructed to.
This function is used to calibrate inverter output energy and voltage. It will not impact the
energy count for inverter with RGM.
Two sections are included: Power Parameter and Voltage Parameter.
YES=<ENT> NO=<ESC>
Power
para
:
1
.
000
.55.
.54.
