Indication LED
•
After power on, the indicator light flashes
red
several times
•
After the device is started, the indicator light will be yellow for
about three seconds. During this period, press the func key to enter
the configuration mode.
•
The indicator led is
green
under normal mining condition.
•
The indicator light is
yellow
during system preparation.
•
When the system is overheated, the indicator light is
red
.
•
During the operation of the system, through FMS software or manually
pressing the func key, the indicator light flashes alternately yellow
and green, and then press again to restore the original color
•
Restore the factory settings: press the func function key when power
on, keep it unchanged for five seconds until the red light flashes,
then press reset or disconnect the power to restart.
Work mode
The device has two working modes: "normal mode" and "configuration mode".
The default mode is DHCP mode.
Normal mode
In normal operation mode, the device runs in this mode most of the life
cycle. In this mode, the network can use DHCP (dynamic acquisition) or
static IP, and the factory setting is DHCP.
Configuration mode
Enter this mode by press the func button during the Red LED light at second
time (about 3 seconds ) at miner start up.
Press the func key before starting and then start the machine. During the
red light period (about three seconds), the device will enter this mode.
In this mode, the IP address is static (address: 192.168.168.168, subnet
mask: 255.255.255.0). The built-in web services of the device can be
accessed through PC browser, and then the network, mine pool, password and
other information can be configured.
After setting the PC to static IP address: 192.168.168.100 (or any other
non conflict address in the same network segment), subnet mask:
255.255.255.0, connect the PC to the same network (under the same switch or
router, or the PC is directly connected with the device network cable).