CAN SL Series, Installation, Use And Maintenance Instruction Manual

Page: 120 / 362

48
ENGLISHENGLISH
OUTSIDE REMOVABLE GAS HOB UNITS
▪
SL series
TROUBLESHOOTING AFTER INSTALLATION
If the appliance does not work properly after installation, perform the controls in the table.
problem potential solutions
There is a smell of gas near
the appliance
Make sure that the gas cocks are completely closed. If the problem has not been
solved, disconnect the appliance from the gas supply and ask for technical support.
There is a smell of gas near
the outdoor gas valve or
connections
Make sure that there are no gas leaks from the quick joint or fitting (by using only a
water and soap solution) and that the flexible hose is not damaged (cut, abraded,
punctured, etc.). If the problem has not been identified and solved, disconnect the
appliance from the gas supply and ask for technical support.
The gas flow
seems irregular
Check that the gas cock is completely open.
Check that the fuel supply circuit has a suitable flow rate.
Check that the burner spreaders and relative caps are positioned correctly and free
from obstructions.
Check that the nozzles are suitable for the type of gas used.
Check compatibility and correct calibration of the pressure regulator, if applicable.
Check that the gas supply hose is not choked/obstructed and that the shut-off valve
on the gas valve is fully open.
If the appliance still does not work properly after all the checks have been made, contact the
authorised local dealer.
ATTENTION!
Always disconnect the appliance from the power line or gas cylinder when not in use.