CAN SL Series, Installation, Use And Maintenance Instruction Manual

Page: 135 / 362

63
ENGLISHENGLISH
Installation, use and maintenance instruction manual
▪
Ed. 11/2019 Rev. 00
step action picture
1 Open the installation recess, release the sliding
base (by lowering both safety levers located
at the end of each guide) and remove the
appliance.
2 Continue removing the product until the end
stop position has been reached: the guides will
automatically lock preventing the base from
being even accidentally slid.
Lift the glass cover of the product.
3 Grasp the free end of the flexible gas hose
and connect the quick joint to the appropriate
approved external valve (as shown in the
figure). Upon proper coupling, a mechanical
click is heard.
Then turn the knob of the safety valve installed
to check for proper quick joint, and power the
appliance.
For F versions, it is sufficient to check the product for stability when it is mounted on legs, and
ensure it is properly connected to the external gas cylinder.
USE
Before using the appliance for the first time, clean it and all of its components as instructed
in the paragraph “Cleaning”.
The first few times the appliance is used, it could release smoke and unpleasant smells.
There is no reason for concern as this is due to the combustion of the grease used to process it in the
factory.
The burners are equipped with safety thermocouple.
The thermocouple is a heat sensitive device: as long as it is heated by the fire of the lit burner, it
allows gas to exit the nozzle; if the fire goes out accidentally (for example when liquid spills from
the pan), the thermocouple will cool off in a few seconds, thus preventing gas from exiting the
nozzle.
use of gas burners
/
controls and their symbols
OFF
MAX
MIN
LIGHTING THE BURNERS
ATTENTION!
Before use, make sure that the burner spreaders, caps and pan holders are positioned properly.
burner spreader positioning
The matching burner is indicated on each knob.
The burner can be lit:
▪
manually using the external igniter (on S versions),
▪
piezoelectrically with mechanically/manually operated piezoelectric igniter (on P versions).
Proceed as follows to
light the burner
:
step action
1
2
1 press the knob corresponding to the burner you
want to light and turn it anticlockwise (to the
maximum symbol).
2 At the same time, operate the piezoelectric
igniter with several fast repeated pulses, or
bring an external manual igniter close to the
burner spreader.
3 When lit, keep the knob pressed all the way
for another 5 seconds (at maximum) and then
release it, adjusting the desired intensity of the
flame.
Please note: this delay in releasing the knob
heats up the safety thermocouple.
If the burner does not remain lit when you release the knob, it means that the thermocouple did not heat
up sufficiently. To solve this problem, repeat the operations described in the table, holding the knob down
longer after the burner is lit.