14
Ultra High Resolution Color Camera
15
Ultra High Resolution Color Camera
3. Remove the cover of the Auto Iris Lens connector plug and solder the lens
cable to the connector pins of the plug.
4. Fit the cover of the auto iris lens connector
plug, remove the protective CCD cover
from the front of the camera, and fasten
the Auto Iris Lens by turning it clockwise.
5. Focus the camera using the Auto Iris Lens
controls, combined with fine adjustment using
using the Back Focus control.
•
For a Video Drive Lens
Pin 1: Red (Power)
Pin 2: NC
Pin 3: White (Video Signal)
Pin 4: Black (Ground)
•
For a DC Drive Lens
Pin 1: Damping -
Pin 2: D
Pin 3: Drive +
Pin 4: Drive -
Using a C/CS mount lens
Before installing a lens, identify whether the lens to be installed is a C-Mount
or CS-Mount. This camera is set for a CS-Mount Lens by default. To install a
C-Mount Lens, a simple modification is required.
• When Using a CS Mount Lens
Remove the protective cover from the front of this product and turn the
CS-Mount Lens clockwise to install it. Focus the camera using the
CS-Mount Lens and Back Focus controls.
• Use a lens threaded as shown in the following figure. If the dimensions
of the thread are incorrect the camera could be damaged, or the lens
may not get installed firmly enough.
• If the lens is too heavy the camera becomes unbalanced, which may
cause problems. Use a lens weighing less than 450g.
• When adjusting the Automatic Level Control (ALC) of an Auto Iris Lens,
use Av mode if available. If Pk mode is used the picture brightness
may change continuously.
Note
connector
Lens cable
No. 3 Pin
No. 1 Pin
No. 4 Pin
No. 2 Pin
C-Mount Lens: 10mm or less
CS-Mount Lens: 5mm or less
Back Focus Control Lever
■
Installation Procedures