5
TORQUE SPECIFICATIONS
Recommended torque specifications according to
bolt size and grade.
NOTE: Use a thread locker (Loctite 262 or equivalent)
at the specific points of the System indicated in
the
User Manual
’s exploded views.
INFORMATION
1. For most vehicles, directional arrows have been cut
out of some components in the anchor bracket kits.
Make sure the arrows point toward the front of the
vehicle when installing the brackets. See Fig. 1
Fig. 1
2. IMPORTANT NOTICE applicable to the following
models:
Sportsman 570 SP / EPS / LE / Premium 2015-2020
Sportsman 570 Touring SP / Premium 2015-2022
Due to the design of this particular vehicule, the
flexible edge of the track comes very close to the
steering mechanism’s upper ball joint. In certain
situations, e.g., when shock absorbers are fully
compressed or when rubber tracks are not touching
the ground, contact between those two components
may take place but without damaging them.
PREPARATION
1. Set each Track System unit near the position
indicated by the sticker affixed on the frame.
Fig. 2
**
IMPORTANT
: Start by installing the REAR Track
Systems first. **
REAR TRACK SYSTEM INSTALLATION
1. Remove rear wheels. Make sure that wheel studs
and wheel hubs are free of dirt.
2. If needed, remove CV joint protectors.
3. Remove bolt, washers and spacer bushings from
rear stabilizing rod end. Discard the M10x60mm bolt
and one of the spacer bushings from the
disassembled set of parts. See Fig. 3
Fig. 3
DIMENSION
GRADE
Nm
lb-
ft
Nm
lb-ft
M6-1.0
10
7
M8-1.25
25
18
33
24
M10-1.5
50
37
70
52
M12-1.75
90
66
125
92
FRONT
Discard
