![background image](http://html1.mh-extra.com/html/campbell/cm106be/cm106be_user-manual_489018032.webp)
CM106BE Tripod
22
Figure 6-17. CMB200 components
6.2.4.3
Assembly
1.
Consult Figure
6-18
and Table
6-1
to determine which brackets are needed at
either end of the brace to attach it to the crossarm and tripod mast or tower.
The figure also indicates what orientation is needed when the small bracket is
used.
Each bracket has a long tab and short tab where the bolts are
attached. The brace arm must be attached to the end with the
long tab.
2.
Attach one end of the brace arm to the tripod mast or tower below the
crossarm. Leave the bolts finger-tight.
3.
Lift the free end of the brace arm to the crossarm and attach it to the crossarm.
Again, only finger-tighten the bolts.
4.
Adjust the position of the brace arm as needed.
5.
Fully tighten the two bolts directly connected to the brace arm, and then
tighten the remaining two bolts to clamp the brace arm to the crossarm and
tower or tripod mast.
NOTE
Summary of Contents for CM106BE
