![background image](http://html1.mh-extra.com/html/campbell/cm106be/cm106be_user-manual_489018026.webp)
CM106BE Tripod
16
Route the 6 mm
2
wire from the ground lug on the bottom side of the enclosure to
the ground lug on the base of the tripod (Figure 6-8). Strip 12.5 mm of insulation
from each end of the wire. Insert wire ends into the ground lugs and tighten.
Figure 6-11. Enclosure with the
–MM bracket
6.1.7.2
Enclosure Mounting to Tripod Leg
An enclosure ordered with the –LM bracket has a bracket on each side of the
enclosure, and a V-bolt bracket for securing the enclosure to a tripod leg.
Attach an enclosure with the –LM mounting bracket to the tripod base as follows:
Slide the keyhole notch in upper corner of the –LM bracket over the extended
hook located on the tripod base as shown in Figure 6-12, and engage the notch in
the lower corner of the –LM bracket with the enclosure tab. There are six places
on the tripod base with provisions for mounting enclosures with the –LM brackets.
Remove the washers, nuts, and V-bolt from the V-bolt bracket. Install the bracket
as shown in Figure 6-12 (top). Tighten the nuts on the V-bolt until the lock
washers are compressed.
Route the 6 mm
2
wire from the ground lug on the bottom side of the enclosure to
the ground lug on the base of the tripod (Figure 6-8). Strip 12.5 mm of insulation
from each end of the wire. Insert wire ends into the ground lugs and tighten.
V-Bolt
Summary of Contents for CM106BE
