User Manual
9
Figure 6-4. Mast attachment to tripod base
Loosen the six bolts on the tripod base. Figure 6-4 shows the location of four of
these bolts. The remaining bolts are in the same position on the third tripod leg.
Slide the mast into the tripod base, making sure that it extends below the lower
bolts and rests on the tabs. Tighten the six bolts to secure the mast.
If required, also loosen the 6 x preset at factory bolts.
Plumb the tripod by adjusting the northeast and south facing legs. With a level on
the East side of the mast, adjust the Northeast leg for plumb. With the level on the
South side of the mast, adjust the South leg for plumb. Tighten the tension bolts
after the adjustments have been made.
Make sure all bolts have been tightened.
Mast
Tab
Bolts
Preset at Factory
Preset at Factory
Summary of Contents for CM106BE
