![background image](http://html.mh-extra.com/html/campagnola/speedy/speedy_use-and-maintenance-manual_488413031.webp)
Use and maintenance manual – Translation of
original Instruction. : 04 date 16/09/2021
Page 31
5.3 Storing the shear
•
Keep the trigger pressed for few seconds until you hear 3 long beeps. The blades close and remain closed. Release the
trigger.
•
Switch the shear off and remove the battery.
•
Recharge the battery before putting it into its box.
•
Clean the shear and put it back with its components into its box.
•
Store the shear in a dry place.
•
For long periods of inactivity recharge the batteries not later than every 3 months.
5.4 Troubleshooting
All the following maintenance operations shall be carried out by a maintenance technician.
FAULT
CAUSE
REMEDY
The shear cannot complete the cut. The branch diameter is over 25 mm or
the wood is too hard
Immediately release the trigger. The cutting
blade will go back to its opening position.
The battery does not get completely
recharged.
•
Degraded battery
•
Faulty battery charger
•
Unsuitable battery charger
•
Check that the battery charger is the one
supplied with the shear.
•
Replace the battery.
•
Replace the battery charger.
Electric/mechanical wrong function-
ing
•
Motor overheating
•
The shear makes noise
Contact an Authorized Service Point
The tool does not work.
Possible electronic or mechanical
problem
Contact an Authorized Service Point
Failure to apply the instructions described in this manual could cause damages or injuries.
6.1 Routine maintenance
•
Before carrying out any routine maintenance operation, put the ON/OFF button (5) in “OFF” position and remove
the battery (12) from the tool.
•
All the maintenance operations which are not mentioned in this manual must be carried out at an Authorized
Service Point.
Routine maintenance operations can be carried out by the operators.
6.2 Sharpening
Correct sharpening of the blade is essential to ensure:
•
cut quality
•
battery life
•
durability of the mechanical parts and the motor
•
durability of the blades
During the first day of use
the burr that is created on the cutting edge of the blade must be removed often. The type and
diameter of the wood being cut determines how often this must be done.
Hard wood with a large diameter:
after 15 minutes
, then every hour.
Soft wood with a small diameter:
after 30 minutes
, then every 2 hours.
(It is good practice to avoid cutting branches that are dry or with a large diameter during the first half hour of work)
After the first day of use
, you will determine how often sharpening is required based on the condition of the blade.
Light but frequent sharpening is recommended.
6.2.1 Replacing the blade
If the cutting blade (1) is worn or if the shear does not guarantee a clean cut after its sharpening, it is advisable to replace
the blade group by following the steps mentioned below.
Before any maintenance operation switch off the shear and remove the battery.