CAME SALOON40, Installation Manual

Page: 26 / 28

p.
2
6
26
- M
an
ua
l c
od
e:
F
A
0
0
0
6
F
A
0006
8
-E
N
8-
E
N
v.
1 1
04/2
01
5 © C
am
e S
.p.
A
. - T
he d
ata a
nd i
nfo
rm
ati
on i
n th
is
m
an
ua
l m
ay b
e c
ha
ng
ed at a
ny ti
m
e a
nd w
ith
ou
t n
oti
ce
.
MAINTENANCE
Before doing any maintenance, cut off the power supply, to prevent any hazardous situations caused by acciden-
tally activating the operator.
To properly maintain the AISI 304 stainless steel, refer to the stainless steel cleaning part of the 119RW48
manual.
Table of the mean cycles between failures (MCBF) of Saloon turnstiles, considering proper installation and mainte-
nance as described in this manual:
Model Operating limits MCBF
001PSSLN40
maximum number of daily cycles: 15,000
Maximum number of cycles per minute: 12 (1 cycle every 5 seconds)
1,200,000
Troubleshooting
PROBLEM POSSIBLE CAUSES FIXES AND REMEDIES
The turnstile does not
execute commands • No power supply
• Stop button open
• Check power network
• Check proper state of the button
The turnstile stays open
after a passage • Automatic closing function deactivated
• Photocells employed
• Call assistance
• Call assistance
Periodic maintenance
• Every 400,000 cycles and in any case every six
months:
• With the main power cut off, check for smooth
sliding and gearmotor reversibility.
• Check proper fastening of nuts.
• Check proper fastening of external tube
screws.
• Check proper fastening of ground anchoring
bolts.
• Clean the inside of the operator from any dust
created during operation.
• Cleaning/lubricating the plastic parts that slide
in contact with the aluminum tube.
• Check that all electrical and wiring connec-
tions are sound and replace any damaged
parts.
• Cleaning of the outer tube (clean with a water-
dampened cloth).
• Keep the stop-go light clean (clean with a
water-dampened cloth).
• If a radar is installed, keep the glass clean
(clean with a water-dampened cloth).
• Check proper positioning of the leaf when
opening and closing (possibly reset the
parameters by following the instructions in the
installation manual).