CAME G2080E, Installation And Operation Manual

Page: 60 / 128

p.
2
8
28
- M
an
u
al
c
od
e:
F
A
0
1
0
3
0
-E
N
FA
0
1
0
3
0
-E
N
v.
11
- 0
1/
2
0
18 - © C
am
e S
.p.
A
. - T
h
e m
an
u
al
's c
onte
nts m
ay b
e e
d
ite
d at a
ny ti
m
e w
ith
ou
t n
oti
ce
.
TROUBLESHOOTING
Er1 The travel calibration was interrupted by the STOP button being activated.
Er3 Encoder broken.
Er4 Services test error.
Er5 Insufficient working time.
Er6 Maximum number of obstructions detected.
Er7 Overheating of transformer / inspection hatch open / boom released from gearmotor.
Er8 Encoder excluded.
C0 The 1-2 (N.C.) contact is open.
C1, C4, C5 or C9 The N.C. contacts are open.
The warning LED is flashing Electronic board not calibrated for travel.
ERROR MESSAGES

The error messages appear on the display or are flagged by an LED
.
PROBLEM REFERENCE CHECK
The boom neither opens nor closes 1-2-3-4-6-8-18 1 - Lock the inspection hatch with the key
The boom opens but does not close 4-7 2 - Deactivate the HOLD-TO-RUN function
The boom closes but does not open 4-7 3 - Check the power supply and fuses
The barrier does not close automatically 11-12-13 4 - The N.C. contacts are open
The barrier does not work with the transmitter 2-14-16 6 - Deactivate the MASTER-SLAVE function
The boom direction of travel is inverted 7-18 7 - Check the boom balance and spring tautness
Only one transmitter works 22 8 - Deactivate the OBSTRUCTION DETECTION function
The photocells do not work 12-23-24 11 - Activate the AUTOMATIC CLOSING function
The warning LED flashes quickly 4 12 - Check the proper direction of travel
The warning LED stays on 13 13 - Check the control devices
The boom does not reach the limit switch 7 14 - Replace the AF card
The boom cannot be balanced 7-15 15 - Check the boom/applied accessories length ratio
The barrier does not slow down 7-15 16 - Save the radio code again
The barrier does not work with emergency batteries 8-25-26 18 - Adjust the sensitivity
The boom starts slowly 7 22 - Enter or duplicate the same code for all transmitters
23 - Activate the photocells
24 - Connect the photocells in series and not in parallel
25 - Check the batteries
26 - Respect the photocell's power supply polarities