Cambium Networks ePMP, User Manual

Page: 113 / 478

CAMBIUM NETWORKS
026v003
113
Attribute Meaning
Subscriber Module
Mode TDD: The SM is operating in the proprietary TDD mode and will only
connect to another ePMP Access Point.
Standard WiFi: The SM is operating in the Standard 802.11n WiFi mode
and will be able to connect to any Access Point operating in standard
WiFi mode.
ePTP Slave: The SM is operating as a Slave in point-to-point mode. The
AP and the system do not support GPS Synchronization in this mode but
are able to provide significantly lower latency than other modes. QoS
(MIR and traffic priority) capability and Link Quality/Capacity indicators
are not available in this mode.
Subscriber Module
Priority The configured priority of the SM in the sector.
Network Mode Bridge: The SM acts as a switch, and packets are forwarded or filtered
based on their MAC destination address.
NAT: The SM acts as a router, and packets are forwarded or filtered
based on their IP header (source or destination) which can be grouped
into subnets for finer granularity.
Router: The SM acts as a router and packets are forwarded or filtered
based on their IP header (source or destination) using specific static
routes and IP aliases configured by the operator.
Downlink RSSI The Received Signal Strength Indicator, which is a measurement of the
power level being received by the SM’s antenna.
Downlink SNR The Signal to Noise Ratio, which is an expression of the carrier signal
quality with respect to signal noise and co-channel interference (or
both).
Uplink MCS Modulation and Coding Scheme – indicates the modulation mode used
for the radio uplink, based on radio conditions (MCS 1-7, 9-15).
Downlink MCS Modulation and Coding Scheme – indicates the modulation mode used
for the radio downlink, based on radio conditions (MCS 1-7, 9-15).
cnMaestro Remote
Management Indicates whether the device is currently configured to be managed by
the Cambium cloud management system –
cn Maestro™.
cnMaestro
Connection Status The current management status of the device with respect to the
Cambium Cloud Server. When Enabled under Configuration->System,
the device will be managed by the Cambium Remote Management
System, which allows all Cambium devices to be managed from the
Cambium Cloud Server.
cnMaestro Account
ID The ID that the device is currently using to be managed by the Cambium
Cloud Server.