Cambium Networks cnReach N500, User Manual

Page: 47 / 236

cnReach N500 User Guide System Configuration
phn-4673_003v000 (November 2018)
2-15
Radio/RF Settings
This section describes the configuration of frequencies, transmit power, hop pattern, and transmit rates.
Note
cnReach radios can be used in full configuration mode or auto-configuration mode. In full
configuration mode, all settings are made on all radios (APs and EPs). In auto-
configuration model, the EP automatically detects many of the air interface settings from
APs beacon signals. This can dramatically simplify the configuration, modification and
maintenance of cnReach networks.
This section refers to the full configuration mode. See the following section which repeats
this information but for those using auto configuration mode.
For new installations, we recommend using auto configuration mode.
Attention
The following radio settings that affect transmission timing must be the SAME in ALL
radios within ALL sub-networks in the system;
- AP/EP Tx Frequency (and for ISM the start/stop and excluded frequencies)
- For ISM, Hop Pattern
- Access Point Transmit Rate
- End Point Transmit Rate(s)
- Max Payload Bytes
- Network Type; PTP or PMP
- Network Radius