CAMBER FSR SERIES, User Manual

Page: 6 / 20

3
seat tube and should be lowered until it can be seen through the sight hole. This may result in the saddle being too
low. If so, the seatpost must be replaced with a longer seatpost.
WARNING! Failure to follow the seatpost and frame minimum insertion requirements may result in
damage to the frame and/or seatpost, which could cause you to lose control and fall.
If the seatpost is cut short, the min/max mark on the seatpost may no longer be accurate. Before
cutting the seatpost, note the min/max depth required by the seatpost manufacturer.
WARNING! For general instructions regarding the installation of the seatpost, refer to the appropriate
section in the Owner’s Manual. Riding with an improperly tightened seatpost can allow the saddle to
turn or move and cause you to lose control and fall.
WARNING! Inspect the seatpost and seat tube to ensure that there are no burrs or sharp edges.
Remove any burrs or sharp edges using fine grit sandpaper.
Do not apply grease to the contact surfaces between the seatpost and the seat tube. Grease
reduces the friction, which is critical to proper seatpost grip. Specialized recommends the
application of carbon assembly compound (fiber paste), which can increase friction between
carbon surfaces. Please visit your Specialized Authorized Retailer for additional information.
PF30 BOTTOM BRACKET
PF30 bottom brackets (73mm width x 46mm): Specialized recommends the use of the SRAM PF30 BB or Praxis
Conversion BB, depending on the desired crank spec. Other crank/BB options exist for PF30 BB shells. Please refer to
the Bottom Bracket Instruction Guide, or to the desired crank/BB manufacturer for additional information.
Refer to the manufacturer’s instruction guide for installation procedures.
Additional information is available at www.specialized.com.
FRONT DERAILLEUR
„
2x-compatible Camber models: compatible only with the SRAM A3 MDM front derailleur with Tace Blade.
S161900001 DER SRAM MY16 FRONT DER X7 MDM 2X10 38/36T BLK BP FOR TACO BLADE
S141900001 DER MY14 ENDURO 29 FRONT DER MOUNT - TACO BLADE WITH BOLT
REAR AXLE
Camber FSR models are equipped with either a 148 Boost or 142+ rear axle system.
„
142 + requires the use of a proprietary Specialized 142+ wheel, or a 142mm compatible rear wheel.
„
148 Boost requires a 148mm Boost compatible rear wheel.
For additional information regarding compatibility, please refer to www.specialized.com.
SPARE PARTS
Specialized offers replacement parts for most FSR models, available through your Authorized Specialized Retailer.
53216-9100 SWAT EMT MINI-TOOL ONLY
SPECIFICATIONS
WARNING! Specialized frames are compatible ONLY with forks that have a specific maximum
amount of travel (see table below). Use of different styled forks or forks with longer travel may
result in catastrophic failure of the frame which may result in serious personal injury or death.
FORK LENGTH:
WHEEL SIZE FORK TRAVEL
650b 130mm
29” 120mm