CAMBER FSR SERIES, User Manual

Page: 14 / 20

11
ALLOY FRAME
Routing options: Choose the desired options for the handlebar controls (Front derailleur, rear derailleur, Command
Post).
REAR DERAILLEUR
1
FRONT DERAILLEUR
COMMAND POST
2
„
Route full length housings into the down tube entry ports for each desired handlebar control.
A
3
REAR BRAKE
4
„
Command Post (Fig.3): Route the housing down the down tube. Once it reaches the bottom bracket junction,
remove the down tube housing exit port and guide the housing up over the bottom bracket shell and through the
seat tube access hole
A
, then up the seat tube.
„
Front/Rear derailleur (Fig.4): Once the housings exit the down tube exit port hole, install the exit port guide onto the
housings, then install the guide into the down tube. Do not fully tighten the guide in place until the housings are fully
routed and the housing loops are correctly positioned.
„
External rear brake (Fig.4):
Alloy frames are equipped with two single-bolt down tube guides (middle and
upper position), one dual-bolt cable down tube guide (lower position) and one single-bolt chainstay guide. Place
the guides over the brake housing and fasten the guides using recessed head bolts (M4 x 13 mm).
„
Trim each housing so that the handlebar can rotate 90 degrees in each direction, and that the distance
between the housing loops and the bottom bracket shell is 35-45mm (Fig.2, page 10).
„
Once all the housings are routed and looped properly under the bottom bracket tighten the down tube guide bolt.
This will secure the housings in the correct position.
„
Alloy frames: Install foam tubing (“churros”) over the derailleur housings before inserting housings into the
frame. This prevents the housings from rattling inside the down tube.