33
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
.
WPS Status
Power-up
Status
Function
LED Appearance
LED Status
Device booting up
Unit is in the process of booting up or
service/software is currently being
upgraded.
LEDs flash every second assuming
software can control the LEDs.
Note
: If the device is connected via
WIRED or WIRELESS backhaul,
ignore pairing and signal strength
behavior.
Alternating on/off at 1000 m/sec per
cycle
875
9
Boot-up Failure
Unit boot-up failed (assume failure
occurs after software has taken control
of the LEDs)
Alternating on/off at 800 m/sec per
cycle
WPS Pressed,
Pairing Attempt
Started
WPS is enabled upon pressing the
WPS a single time. The device will stay
in pairing mode for 120 seconds.
During this time, other Wi-Fi capable
devices can be paired to the Gateway
Wi-Fi radios (5.0 GHz band) by
initializing a similar WPS function on
the other unit or mesh satellite thereby
creating an association with the
Gateway SSID and the mesh satellite.
When the Gateway and the mesh
satellite are successfully paired, they
will have the same primary SSID (2.4
and 5.0 GHz).
WPS LED behavior takes priority even
if Alexa is used during the pairing
period.
LED bar begins flashing at 500 m/sec
intervals and continues for at most 120
seconds.
Gateway Not Found
If no device is found after the initial 120
second time-out, the WPS/Strength
LED bar shifts from the blinking green
to solid red.
LED bar remains red for another 60
seconds, then reverts to the "No
Internet failure status.
Summary of Contents for GigaSpire BLAST u12
Page 1: ...GigaSpire BLAST u6 u12 Installation Guide November 2021 220 01209 11 ...
Page 2: ......
Page 24: ...24 Proprietary Information Not for use or disclosure except by written agreement with Calix ...
Page 38: ...38 Proprietary Information Not for use or disclosure except by written agreement with Calix ...
