27
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
5.
Attach the Ground Strap to the ground shield.
6.
Using electrical tape, wrap the connections just made to minimize the effects of
corrosion.
7.
Push the Drop Cable Grommet into position and secure the cable to the chassis using tie
wraps.
5231
Ground Shield
Wrapped in Electrical
Tape
Secure Drop Cable
with Tie-Wraps
Buffer Tube
Drop Cable
Bracket
Ground Strap
Attaches Here
(1/4 inch nut)
Installing the Power Cable
To install the power cable
1.
Pierce a hole near the back of the power supply grommet.
2.
Slip the power cord through the grommet.
Note:
A majority of the power cord must be threaded through the grommet. The plug
on the end of the cord attaches to the MEM (to be installed in a later step) near the
upper left hand corner of the chassis. Leave only enough slack to reach this distance. The
remaining length (about 29’ can be coiled up and left near the unit temporarily.)
3.
Route the connector end of the cable up the left hand side of the chassis and secure it
using tie wraps.
© 2001-2007 Calix. All Rights Reserved.
