20
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
© 2001-2007 Calix. All Rights Reserved.
Unpacking Instructions
The ONT comes shipped with all covers attached.
To unpack the Model 560 ONT
1.
Remove the temporary fastener from the subscriber security latch on the right hand side
which keeps all the covers in place.
2.
Swing the outer cover open.
3.
Loosen the security screw which fastens the inner cover. Swing this cover open as well.
Tools Required
In order to install the ONT, the following tools are necessary:
y
3/8” Drill (for drilling the mounting holes).
y
Drill Bits appropriate for wall anchors or fasteners of choice.
y
7/16” nut driver for securing ground strap and the Main Electronics Module (MEM).
y
Reversible 5/32 and 5/16 inch combination hex pin wrench (Calix part number 100-
00714).
y
Wire strippers.
y
Utility knife, box cutter (for unpacking).
y
Coaxial connector stripper and crimper.
y
Flat head and #2 Phillips Head screwdriver.
y
Fiber Splicing Tools.
y
Fusion Splicer for fiber optic cable.
y
Carpenter’s level.
y
Optical Time Domain Reflectometer capable of calibration between 1310 and
1550nm output.