25
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
Board Mounting
Post
Fiber Management
Tab
Outer Cover
Fiber Splice
Tray
Inner Cover
Spiral Protective
Tubing
Board Mounting
Post
Mounting Location
Ground Bus Lug
Riser Pipe Grommet
Incoming Local
Power Grommet
All Outgoing Converged
Services Exit Here
(Voice, C ATV, Data )
3330
Mounting
Location
Cable Management
Tie-dow n
Tip and Ring Pos t
Board Mounting
Post
ONT Chassi s
Board Mounting
Post
Mounting Location
Installation Procedure
DANGER!
High voltage electrical and pressurized natural gas lines may be
present. Make sure you fully understand the locations of these and all other
utility connections.
Mounting the ONT
To mount the ONT
1.
Determine the location of the ONT. Plan to mount the chassis roughly at eye level for
ease of installation and service.
2.
Using the ONT enclosure and a level, mark the three mounting hole locations.
3.
Using the correct drill bit for the screws required, pre-drill the marked locations as shown
in the previous illustration.
4.
Using appropriate fasteners for the material being used, mount the ONT enclosure to the
building.
© 2001-2007 Calix. All Rights Reserved.