![background image](http://html1.mh-extra.com/html/calimet/cm6/cm6_installation-and-owners-manual_3445000018.webp)
The gate travel limit controls the position of where the
gate opens and closes.
1. Use a screwdriver to loosen the 3 screws on the
top limit cam. Do the same for the bottom limit
cam.
3. Use the screwdriver and screw back in the limit cam screws.
Output Shaft
Limit Cam
Limit Switch
Limit Cam
2. If gate opens to the right (clockwise):
The top limit cam controls the open limit
◦
Turn the top limit cam counter clockwise to
increase open distance
◦
Turn the top limit cam clockwise to decrease
open distance
The bottom limit cam controls the close limit
◦
Turn the bottom limit cam clockwise to
increase close distance
◦
Turn the bottom limit cam counter clockwise
to decrease close distance
2.
If gate opens to the left (counter clockwise):
The top limit cam controls the close limit
◦
Turn the top limit cam counter clockwise to
increase close distance
◦
Turn the top limit cam clockwise to decrease
close distance
The bottom limit cam controls the open limit
◦
Turn the bottom limit cam clockwise to
increase open distance
◦
Turn the bottom limit cam counter clockwise
to decrease open distance
Top limit Cam,
Gate fully opened
Bottom Limit Cam,
Gate fully Closed
Top Limit Cam,
Gate fully Closed
Bottom Limit Cam,
Gate fully Opened
Step 7: Adjust Gate Travel Limits
TIP
:
For the next step below, use the OPEN, CLOSE, STOP
buttons on the circuit board for efficient positioning. Press
the STOP button before the gate hits the end. The gate
should stop about 1/2 an inch before it hits the end. The
gate should not touch the end of the wall or post.
17