Calian SatService sat-nms ACU2-19V2, User Manual

Page: 8 / 100

Germany
phone +49 7738 99791-10
www.satnms.com
2 Safety Instructions
Safety
The mains shall only be connected provided with a protective earth wire. Any interruption of the
protective wire, inside or outside the sat-nms ACU, is likely to make the unit dangerous.
Intentional interruption is prohibited.
The unit described in this manual is designed to be used by properly-trained personnel only.
Adjustment, maintenance and repair of the exposed equipment shall be carried out only by
qualified personnel who are aware of hazards involved.
Refer servicing to qualified personnel.
To prevent electrical shock, do not remove covers.
For the correct and safe use of the instrument, it is essential that both operating and servicing
personnel follow generally accepted safety procedures in addition to the safety precautions
specified in this manual.
Whenever it is likely that safety protection is impaired, the unit must be made in-operative and
secured against unintended operation. The appropriate servicing authority must be informed. For
example, safety is likely to be impaired if the unit fails to perform the intended measurements or
shows visible damage.
Ensure that the cabinet is proper connected to the protective earth conductor.
The circuit breaker, that fuses the mains for the sat-nms ACU has to switch off all phases AND the
neutral wire as well.
WARNINGS
The outside of the equipment may be cleaned using a lightly dampened cloth. Do not use
any cleaning liquids containing alcohol, methylated spirit or ammonia etc.
Follow standard Electrostatic Discharge (ESD) procedures when handling the Unit.
Apply the appropriate voltage according to the attached schematic.
In case of switching off all the circuit breakers is still voltage available at the mains terminals!
Only use shielded cable to connect the AZ- and EL-Motor. The other components in the
cabinet might be jammed through the harmonic waves the frequency inverters inject into the
motor wires.
Use only double shielded twisted pair cables (e.g. CAT7 Ethernet cable) to connect the
resolvers to the sat-nms ACU
Only ACU-ODU : If the Unit is equipped with an optional air ventilation, avoid direct contact
with jets of water, normal rain is no problem.
3 The sat-nms ACU19V2
The sat-nms ACU19V2 is an advanced automatic tracking antenna controller. It can be used as a
cost efficient antenna tracking system to replace the Vertex / General Dynamics Satcom
(C) 2022, SatService GmbH www.satnms.com ACU2-19V2-UM-2209 Page 7/99