9
GRILL LIGHTING INSTRUCTIONS
WARNING: !
TO MATCH LIGHT THE GRILL
IMPORTANT!
After several attempts, if the burner will not light
using the built-in igniter, then the burner can be
Having more than two burners on high
match lit. Use an extra long match or use a regular
with the roasting hood closed may damage
sized match and the extension rod provided (on a
the internal components of the barbecue.
chain behind the front accessory doors). Simply
And cause discolouration of the stainless
place an unlit match between the coils at the end of
steel.
the extension rod.
BEFORE LIGHTING
If you've just attempted to light the burner with the
Inspect the gas supply piping or hose prior to
igniter, allow 5 minutes for any accumulated gas to
turning the gas “ON”. If there is evidence of
dissipate. Keep your face and hands as far away as
cuts, wear, or abrasion, it must be replaced
possible. Insert a lit extended match into the hole on
prior to use. Do not use the grill if the odour of
the left side of the cart. Press the control knob and
gas is present.
rotate left to the “HI” setting, which should release
the gas. Burner will light immediately.
With a propane barbecue, ensure the tank is
securely closed. Screw the regulator (type
Note: If ignition does not immediately take place,
QCC1) onto the tank. Leak check the hose and
turn the burner valve handle to “OFF”, wait 5
regulator connections with a soap and water
minutes, and repeat the lighting procedure.
solution before operating the grill (see leak-
testing instructions in this manual).
CHECKING BURNER FLAMES
Flames should be blue and stable with small yellow
With a propane barbecue, turn your propane
tips. There should not be excessive noise. The flames
tank on slowly so as not to trick your tank into
should not “lift” off the burner. The flames should
thinking there's a leak in the tank (see bottom
not be totally yellow. If any of these conditions
of page 12).
exist, check if the air shutter or burner ports are
blocked by dirt, debris, spider webs, etc.
TO LIGHT THE BARBECUE
Following the operating instructions, light each
Turn all knobs to “OFF” then turn on the gas
burner and check for a clear blue flame with just a tip
supply. Always keep your face and body as far
of yellow. If necessary, avoid excess yellow tipping
from the grill as possible when lighting.
by adjusting the screw on the side of the burner
Open the lid, push and turn one control knob
counter-clockwise (see Fig. below).
slowly to the “HI” position. Upon hearing gas
flow, (a faint hissing sound) continue holding
the knob in position to accumulate a small
amount of gas for ignition. After three to four
seconds, continue to turn the knob to “HI” to
light the burner. If the burner does not light,
turn all burners “OFF” and wait 5 minutes.
Then repeat the above process.
