P4, P5, and P6 Barbecue Grills
LTR50001137, Rev. K
Appendix
www.calflamebbq.com
32
You will need:
•
6mm socket or nut driver
•
Two to five 1.9mm orifices (depending on
your grill
•
Pipe compound suitable for natural gas
b. Remove the locking pins from the end of the
burners.
The locking pins are accessible by removing the
drip tray and tilting the grill back. They can be
seen underneath the grill in the back. See figures
below.
c.
Remove all burners by carefully lifting them up
and away from the valve orifice.
d.
Using a 6mm socket or nut driver, remove the
orifice for the burner.
e.
Apply a small amount of pipe compound to the
orifice threads.
f.
Screw in the orifice until it is finger tight.
g. Tighten the orifice with the 6mm wrench.
h.
Repeat the above steps for the remaining burners.
i.
Replace the burners, flame tamers, drip tray, and
grates.
You do not need to replace the locking pins. They
are used to keep the burners in place during
shipping and are not necessary to operate your
grill.
WIDTH
WIDTH
WIDTH
WIDTH
Minimum
Clearance
12” Minimum Distance
Between Grill and Side Burner
Minimum
Clearance
Screen Vents
WIDTH
WIDTH
WIDTH
DEPTH
WIDTH
WIDTH
DEPTH
WIDTH
WIDTH
WIDTH
DEPTH
DEPTH
DEPTH
HEIGHT
HEIGHT
HEIGHT
Burner
Locking Pin
Burner
Locking Pin
Orifice
1 . Replace the main burner orifices
a.
Remove the grates, flame tamers, and drip tray
from the grill. See figure below.
Step 2: Changing the burner orifices
