CAEN
Electronic Instrumentation
DT55xxE Desktop HV Power Supply
10
3.
Unit operation
Initial inspection and Safety requirements
N.B. read carefully the “Precautions for Handling, Storage and Installation” document provided with
the product before starting any operation!
The following HAZARD SYMBOLS are reported on the unit:
CAUTION:
indicates the need to consult the
“Precautions for Handling, Storage and
Ins
tallation”
document provided with the product.
A potential risk exists if the operating
instructions are not followed
HIGH VOLTAGE:
indicates the presence of electric shock hazards. Enclosures marked with
these symbols should only be opened by CAEN authorized personnel.
To avoid risk of injury from electric shock, do not open this enclosure
Prior to shipment this unit was inspected and found free of mechanical or electrical defects. Upon
unpacking of the unit, inspect for any damage, which may have occurred in transport. The inspection
should confirm that there is no exterior damage to the unit, such as broken knobs or connectors, and that
the panels are not scratched or cracked. Keep all packing material until the inspection has been
completed. If damage is detected, file a claim with carrier immediately and notify CAEN. Before installing
the unit, make sure you have read thoroughly the safety rules and installation requirements, then place
the package content onto your bench; you shall find the following parts:
DT55xxE desktop power supply unit;
External AC/DC power supply with separate power cord
USB cable
10BASE-T Ethernet cable
Moreover, an external PC is required (supported OS: Windows 7 or later; Linux kernel Rel. 2.4 or later)
Installation
USB installation
Connect the DT55xxE to the AC/DC power supply through the DC input rear connector;
Connect the external AC/DC power supply to Mains (AC) via the separate power cord
Connect the DT55xxE to the PC via the USB cable
Power up the DT55xxE through the ON/OFF rear switch (see p. 8)
Download and install the USB driver for your OS, available at the DT55xxE page on the www.caen.it site
Now the DT55xxE is ready for operation, upon installation of one of the available software tools.
Ethernet installation
Connect the DT55xxE to the AC/DC power supply through the DC input rear connector;
Connect the external AC/DC power supply to Mains (AC) via the separate power cord
Connect
the Ethernet port of the unit to the relevant port of the PC, using the 10BASE-T Ethernet cable
Power up the DT55xxE through the ON/OFF rear switch (see p. 8)
Now the DT55xxE is ready for operation, upon installation of one of the available software tools.
Software tools
GECO2020
CAEN GECO2020 is a graphical application that allows to control the DT55xxE HV Desktop Power Supplies
(and all other CAEN Power Supplies). Once the DT55xxE is correctly installed, download and install the
GECO2020 software package related to your OS; follow the instructions in the GECO2020 User manual
and the DT55xxE will be ready to be operated.
For more info please visit www.caen.it
(products>firmware/software section).
