Caen RFID Hex R1290I, Technical Information Manual

Page: 31 / 57

CONFIGURATION USING THE WEB INTERFACE - Hex R1290I Technical Information Manual 31

Trigger Button: through this option, you can enable or disable the tag inventory on trigger button press. The
Trigger Button options are the following :

Enable (one shot): enable the tag inventory at the trigger button press. When the Trigger Button is
enabled (one shot), to perform the tag inventory just hold down the trigger button and then release.
The reader performs a single inventory cycle.

Enable (start/stop): enable the tag inventory at the trigger button press. When the Trigger Button is
enabled (start/stop), to perform the tag inventory just hold down the trigger button and then release.
The reader performs inventory cycles until the trigger button is pressed for the second time (stop).

Disable: disable the tag inventory on trigger button press.
By default, the Trigger Button is disabled. You can change the default value using the drop-down menu.
Through this option you can enable(one shot)/enable (start-stop)/disabled the tag inventory at the press of
the trigger button of the reader.

Proximity Sensor Trigger: enable or disable. By default, the Proximity Sensor Trigger is disabled. You can
change the default value using the drop-down menu. When the Proximity Sensor is enabled, the reader
performs a tag inventory when he perceives a decrease in brightness due to the passage of a tag. Note that
the sensor is also sensitive to the change in brightness due to the turning off of the light or the passage of a
shadow.

Tag ID Beep: enable or disable. By default, the Tag ID beep is disabled. You can change the default value
using the drop-down menu. If the Tag ID beep is enabled, the reader will beep when a tag is detected.

Tag ID Lights: enable or disable. By default, the Tag ID lights are disabled. You can change the default value
using the drop-down menu. If the Tag ID Lights are enabled, the reader will lights up when a tag is detected.

Keyboard Layout: The Keyboard options are the following:

QWERTY: standard QWERTY keyboard

AZERTY: French keyboard
By default the Keyboard is set to “QWERTY”. You can change the default value using the drop-down menu.

Antenna Source: internal or external. By default, the Antenna src is set to “internal”. You can change the
default value using the drop-down menu.
The external antenna is not supplied, the user can attached his own external antenna to the reader using
the
External Antenna Port (see § Fig. 1.3: Hex R1290I Interfaces Panel and Tab. 1.2: Hex R1290I Interfaces
Panel page 8).

Scan delay (ms): the scan delay is the time between two inventories (in case of continuous inventory mode
with no triggers enabled). Note that if the trigger button and proximity sensor parameters are enabled, the
scan delay is ignored.

Tag Filtering Time (sec): this option is useful to avoid the retransmission of the same tag for a time equal to
the tag filtering time . By default, the Tag Filtering Time is set to 0 and the tag is transmitted at each reading.
For example, if tag filtering time is set to 5s and a tag is read, it is transmitted the first time then it will be
retransmitted after 5 seconds if read again.