-
Hex R1290I Technical Information Manual
16
3
CONFIGURATION MENU VIA READER
Introduction
The reader can be configured via reader menu or using the web interface.
This chapter helps you to configure the Hex reader using the reader configuration menu.
For information on the configuration using the web interface, please refer to the chapter
Connect the Hex to the power supply, the power LED will turn on, wait about 25 seconds until you hear a beep.
When the message “Local Menu” appears on the screen, hold down the
trigger
button to access the main
configuration menu of the reader:
Note that if the trigger button is not pressed in few seconds, the reader starts with the current active profile.
When access the main configuration menu, to scroll through the menu options, press the
up
and
down
buttons.
The Hex R1290I menu options are the following:
INFO
NETWORK
RFID
QUIT
To select a menu option, press the
trigger
button.
Warning:
If your reader is powered on and you want to access the configuration menu, you must first turn
off the reader (disconnect the power supply),
wait about 10 seconds
, turn on the reader again (connect
the power supply) and follow the procedure described above.
