www.cadis.be | [email protected]
Water at the heart of our technology
The home page displays the system’s status, the status of the two leak detection channels and the status of the 8
wireless sensors.
•
Cable length: this is the total cable length that is connected to the channel.
•
Leak location: this is the location where leak alarm is active.
•
Leak zone: this is the zone where leak alarm is active.
•
Leak value: this is a value expressed in %, this value is 100% for a leak.
•
YB resistance loop: this is the measured resistance value in ohms of the Yellow-Black detection loop.
•
RG resistance loop: this is the measured resistance value in ohms of the Red-Green detection loop.
•
Alarm timestamp: this is the time that an alarm is activated.
The status of each wireless sensor is displayed. The following statuses are possible:
•
No Leak
The wireless sensor is in normal operation.
•
Leak
A leak has been detected by the wireless sensor.
•
Timeout
No signal has been received from the wireless sensor in the past two hours.
•
Not activated The wireless sensor on the AQUAVISION 2DETECT has not been activated.
If in the event of an alarm, the alarm buzzer is activated, it can be cancelled by using the “Stop Alarm Buzzer”
button.
Per circuit, it is possible to load a PDF site plan of the leak detection into the AQUAVISION 2DETECT. Click the
“Plan” button per channel to view.
By using the additional features, it is possible to zoom in to the plan or to print it.
