Windshield Washer
{
CAUTION:
In freezing weather, do not use your washer until
the windshield is warmed. Otherwise the washer
fluid can form ice on the windshield, blocking your
vision.
J
(Washer Fluid): Press and release this paddle,
located at the top of the turn signal/multifunction lever,
to spray washer fluid on the windshield. The wipers
will clear the windshield and either stop or return to the
preset speed. For more washer cycles, press and hold
the paddle.
_
(Heated Washer Fluid): The heated windshield
washer fluid system, if the vehicle has this feature,
may be used to help clear ice, snow, tree sap, or bugs
from the windshield. Slide the control on the turn signal/
multifunction lever to this position and then release, to
activate the heated windshield washer fluid system.
This activation initiates four heated wash/wipe cycles.
The first heated wash/wipe cycle may take up to
40 seconds to occur, depending on outside temperature.
After the first wash/wipe cycle, it may take up to
20 seconds for each of the remaining cycles. The heated
windshield washer fluid system may be turned off at any
time by sliding the control on the turn signal/multifunction
lever to this position again.
When the heated windshield washer fluid system is
activated under certain outside temperature conditions,
steam may flow out of the washer nozzles for a short
period of time before washer fluid is sprayed. This is a
normal condition.
WASHER FLUID LOW ADD FLUID will be displayed on
the Driver Information Center (DIC) when the washer
fluid is low. See DIC Warnings and Messages on
page 3-73.
3-15
Summary of Contents for 2009 DTS
