Cactus Laser Trigger LV5, User Manual

Page: 18 / 40

16
4. Setup is complete and the equipment is ready for use.
5. When an object passes through the laser and blocks
the Sensor from detecting the laser, the LV5 triggers
the camera to start taking multiple shots until the
object no longer blocks the laser.
6. Once the laser signal is detected by the Sensor again,
the LED turns green and LV5 is ready for the next group
of multiple shots.
7. Follow the same procedures and set camera’s shutter
speed to Bulb to take Bulb exposure shots. When an
object passes through the laser, the LV5 triggers the
camera to open its shutter. When the object no longer
blocks the laser, the LV5 triggers the camera to close
its shutter.
7.3
LV5 Escape
Mode
LV5 triggers the camera shutter when an object moves away
from the laser signal.
Make sure the Sensor is OFF. Press and hold the ON/OFF
Switch for 5 seconds. The Sensor is ready and functions in
Escape Mode when the LED is steady red.
To cancel Escape Mode, switch off the Sensor.
7.3.1 Single Shot
1. Connect the Sensor to your camera.
2. Switch on the Emitter. The Status LED blinks orange
every 3 seconds.
3. When the laser is detected, the Status LED light turns
to steady orange.
4. Place the object between the Emitter and Sensor, blocking
the laser. The Status LED turns red. The LV5 is now
ready.
5. Once the object moves away and the laser is detected
again by the Sensor, the camera’s shutter releases and
takes one shot.