14
7.1
Before Use
7. Basic Operation
Pair up the Emitter and Sensor within 1m by aiming the
laser at the Sensor until you see a steady green LED.
7.2
LV5 Trap
Mode
Tips: To prevent the laser beam -- i.e., typically a red
spot on your subject -- from appearing in your images.
Position the laser so that it hits the subject on the side
facing away from the camera.
5. Switch on both the Emitter and Sensor by pressing the
ON/OFF switch once. The Sensor status LED blinks green
every 3 seconds.
Caution: Do not point the laser at your eyes.
7.2.1 Single Shot
LV5 triggers the camera to take one shot when laser signal
is intercepted.
1. Set the Sensor to
Single Shot.
2.
Switch on your camera and set the drive mode to
Single Shot
(see your camera’s user manual for
corresponding function key).
3. Connect the Sensor to the camera (see Section 6.7).
4. Place the Emitter and Sensor to the desired
location and adjust the angle of the laser path so that
the Sensor can detect the laser like the image below:
Summary of Contents for Laser Trigger LV5
Page 1: ...User Manual Laser Trigger LV5...
Page 2: ......
Page 39: ......
Page 40: ...www cactus image com...
