CAC / BDP 8kW, Owner'S Manual

Page: 87 / 116

Installation Instructions
GenReady Load Center EZ Transfer™ Operator
M o d e l # 0 0 5 4 4 7 - 0
Revision D (04/17/08) Printed in U.S.A
P/N 0G6419
DANGER

Hazardous voltage that will cause
death, serious injury or substan-
tial property damage. Turn off
power supplying this equipment
before working inside.
This instruction sheet outlines the gener-
al installation procedure. It is not intend-
ed to cover all details or variations in
equipment nor does it provide for every
possible contingency to be met in con-
nection with installation. If unsure of the
correct procedure, have any questions,
or need assistance, contact a qualified
electrical contractor.
This device should be installed in accor-
dance with all local electrical codes
and/or the latest edition of the National
Electrical Code®.
NOTE: The GenReady Panel is de-
signed to be directly compatible with any
Generac manufactured product. Use of
another manufacturer’s generator may
require the purchase and installation of
additional sensing and control compo-
nents.
STEP 1:
Remove the six (6) screws that hold the
trim (front cover) on. Remove the trim
from the front of the panel board.
STEP 2:
a. Open outer trim door exposing the
upper pan (dead front).
b. Remove all twist-outs covered by
existing labels.
c. Apply one of the ATS Danger decals
to the load center as shown in the
following figure.